24/7 EMERGENCY SERVICE — (980) 467-2215
GENERATOR INSTALLATION

Generator hookups done with a real transfer switch

Storms take the Charlotte grid down a few times a year, and the fix people improvise is genuinely dangerous. We install standby generators and portable generator inlets with a proper transfer switch, so your power comes back without backfeeding the line a utility crew is working on.

Licensed NC electrical contractor
Fully insured & bonded
Background-checked electricians
4.9 average rating

What we install

Whole-home standby generators on a concrete or composite pad
Automatic transfer switches that swap over without you being home
Portable generator inlets with a manual interlock kit
Dedicated critical-loads subpanels for heat, fridge, well pump and internet
Natural gas and propane connections coordinated with your plumber
Replacement of an existing generator that has aged out

What's included

Load assessment and unit sizing
Automatic or manual transfer switch
Critical-loads subpanel where that is the better answer
Permit and county inspection
Gas connection coordinated with a licensed plumber
Live load test and handover walkthrough
HOW IT GOES

The process, start to finish

01

Decide what has to stay on

A whole-home standby unit and a critical-loads setup are very different budgets. We start by asking what actually has to run, because for a lot of families the answer is smaller than they expect.

02

Size and site the unit

We size to the real load, then site the unit for clearances, exhaust, and noise — which matters more than people think on a small Charlotte lot.

03

Transfer switch and permit

The transfer switch is the part that makes this safe and legal. It is permitted and inspected, and we coordinate the gas connection if the unit runs on natural gas or propane.

04

Test under load

We do not hand over a generator we have only heard idle. We cut the service and confirm it carries the load it was sized for, then walk you through the exercise schedule.

PRICING

What a generator install costs

A portable generator inlet with an interlock kit typically runs $850–$1,600. A whole-home standby installation, including the transfer switch and pad but not the unit itself, generally runs $3,500–$7,000 depending on the distance from the panel and the gas run. We quote the electrical scope in writing and are clear about what sits outside it.

A residential standby generator on a concrete pad beside a brick home
FREE QUOTE

Tell us what's going on

Send it over and a licensed electrician calls you back within one business hour, 7am to 7pm. Firm written quotes, permitted work, no surprises at the invoice.

Free, no-obligation quotes
Same-week appointments across the metro
24/7 line for genuine emergencies
Get a quote
We reply within one business hour, 7am–7pm.
QUESTIONS

Generator Installation questions

For one appliance, carefully, yes. What you must never do is backfeed the house through a dryer outlet — it energizes the utility line outside and it kills line workers. An inlet and interlock kit is a modest job that makes the safe way the easy way.
Most people do not. A critical-loads setup that keeps the heat, the fridge, the well pump and the internet running covers the actual problem for a fraction of the cost. We will say so even though it is the smaller sale.
Either. We install owner-supplied units without complaint, and we will tell you honestly if the unit you are looking at is undersized for what you described.

Ready when you are

Firm quotes. Permitted work. A garage-floor-clean guarantee.

Call (980) 467-2215 Request a Free Quote